- 3D Front Bumper V3
- Body Stiffener
- ARROWMAX 4D Setup System Stand
- Caster gauge for MTC2/HUDY gauge
① 3D Front Bumper V3 Series for various companies
Based on the V2 series, the bottom surface is two-thirds.
This makes the bumper a combination of the best of both the "bottomed" and "bottomless" V2 series bumpers.
The thickness of the bumper is standardized to 6 mm for all vehicle models, making it extremely thin.
This keeps the weight down.
The curve at the front end is shaped to fit the Twister body.
This is a very well-balanced bumper with straightforward movement that anyone can use.
On the other hand, if you want to pinpoint the settings, the V2 bumper is more effective.
Since bumpers are setting parts, why not keep several different types in your toolbox?
② 3D body stiffener (for front window)
The most commonly used Twister body is 0.4mm thick, which makes it very thin.
It acts as a stiffener for reinforcement.
It uses a φ1.2mm carbon shaft, which improves rigidity.
The shaft is not too stiff, and is flexible so it is less likely to develop strange habits.
It is made very lightweight.
The base part in the middle flexes and fits flexibly to the curved surface of the roof.
The "reference position" for pasting is the top edge of the front window.
Attach it to the roof using double-sided tape, lining up with the line at the top of the front window of the Twister body.
The sides are also secured with double-sided tape.
Tape is not included, so please use your own preferred tape.
You don't have to stick it in this exact position, so it's fun to try sticking it in different positions and enjoy the variations.
It is designed to fit the Twister, but I think it can be used with other bodies as well.
(We have not tested it on all the bodies on the market, so we cannot say for sure that it can be used.)
③ ARROWMAX 4D Setup System Stand
This is a stand for the Arrow Max 4D setup system.
The photo shows it in grey, but the final product will be black.
If you place two of them together with the gold printed sides facing outwards, they will fit perfectly.
The size of the stand has been made as small as possible so that it can be placed neatly on the PIT table.
How about using this as an item to create a cool pit?
④ Caster gauge for MTC2/HUDY
This is a tool for measuring MTC2 casters.
The length of the needle is adjusted to the HUDY gauge shown in the photo.
HUDY's new gauge is also available.
At this time (September 2023), I think the gauge shown in the photo is the one I use most often.
(It has not been verified whether it will fit other companies' gauges. If you would like to verify it, please contact us.)
To use it, simply loosen the single screw that secures the caster block, slide it in from the side, and then lightly retighten the screw.
This is an essential item since the MTC2R has a structure that makes it difficult to align the casters on the left and right sides.
This last one is just a side note.
I think some of you may already know.