Thank you for visiting us!
Mounting a body onto a machine is quite a difficult task.
The time can change dramatically just by changing the body's mounting position.
Therefore, we have launched the new "Body Height Cam"!
Without further ado, here is the product!
There are 8 of the same item in one set.
The adjustment range is 3 levels: "0.5", "1.0" and "1.5" (unit: mm).
Although it depends on the manufacturer, the hole spacing for most body posts is around 2mm.
So, by using the "Body Height Cam" you can adjust the distance to the next hole in 4 steps .
To use it, simply pass any spare pins used for things like wheel hubs, double cardans, or differential joints through the body post.
It is better to have the pins tightly packed rather than loosely packed, as they will not fall out easily.
The hole diameter of the body post varies depending on the manufacturer, so it will look better if you use a drill 0.2mm smaller than the pin size you are using to drill the hole before inserting it.
By the way, if you don't want to modify it, use a φ1.5mm pin for Yokomo Infinity.
For Mugen, Tamiya, and XRAY, a φ2mm pin will fit perfectly.
In either case, the length of the pin will not affect the fit of the product, but a length of around 11mm will give a neater look.
Simply pass it through the "Body Height Cam" and it's complete.
Fine adjustments can be made quickly and easily on site.
I'm concerned about the weight though...
Only 0.34g for 4 pieces!!
The weight is not noticeable at all.
Please give it a try (^^♪
The product page is here .